BPC PowerMaster Manuale Utente Scaricare il pdf (Pagina 8)

Wiring Your Block Power Controller

Assigning the accessory ID#'s to the blocks of track

In the previous section, you set the BPC to control either two or four blocks of track.

To do so, you entered either 98 or 99. Those numbers are reserved for setting the

number of outputs, so do not attempt to assign accessory (ACC) ID#’s 98 or 99.

Choose a number from 1 to 97.

ach block of track that is controlled by the BPC has a unique accessory (ACC) ID# that you

may assign. Keep in mind that you only need to assign the first ID# to each BPC, and the

remaining blocks will automatically be assigned the next consecutive ID#'s.

If you are using multiple BPCs, be sure to assign ID#'s that are different from the numbers

assigned to the other BPC.

It is not necessary to have the outputs connected when assigning the accessory

(ACC) numbers.

1. Remove the RUN/PROGRAM jumper on the side of the BPC unit.

You should assign ID#'s to only one BPC at a time. Remove the jumper only from

the BPC that you are setting.

Pull the small black connector out from the terminal at the side of the BPC unit. Refer to

Figure 3 for the location of the jumper.

2. Press the ACC button on your CAB-1 Remote Controller.

3. Enter the ID# into the CAB-1 Remote Controller with the numeric keypad.

Keep in mind that you are assigning all of the ID#'s when you enter the

first. For example, if you enter ID# 5 and you have four blocks, the ID#'s

will be 5, 6, 7, and 8.

When assigning ID#'s to the BPC, you only need to assign the first ID#. The

remaining ID#'s are automatically assigned.

• When using two blocks of track (ID 99), ID#'s are automatically assigned in pairs. For

example, if you assign accessory ID# 3, the remaining ID# is 4.

• When using four block of track (ID 98) the three

remaining ID#'s are automatically assigned. For example,

if you assign ID# 5 to the first block, the remaining blocks

will be ID#'s 6, 7, and 8.

4. Press SET on your CAB-1 Remote Controller.

The L.E.D. illuminates for one second.

5. Replace the RUN/PROGRAM jumper at the

side of the BPC unit.

Figure 3. Jumper location

Note!

LED

Note!

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Nessun commento

BPC PowerMaster Manuale Utente Pagina 8