BPC PowerMaster Manuale Utente Scaricare il pdf (Pagina 7)

Setting the BPC to control either four or two blocks of track

ach BPC is capable of controlling either two or four blocks of track. Before you assign the

individual ID#s to the blocks of track (the outputs of the BPC), you must tell each BPC

whether two or four blocks will be connected.

• To control two blocks of track per BPC, set the BPC to ID 99.

• To control four blocks of track per BPC, set the BPC to ID 98.

ID 98 is the factory default setting.

1. Remove the jumper from the side of the BPC unit. Refer to Figure 3 on

page 8 for the location of the jumper.

2. Press the ACC button on your CAB-1 Remote Controller.

3. Using the numeric keys on the CAB-1 Remote Controller, enter 98 to

control four blocks of track OR enter 99 to control two blocks of track.

4. Press the SET button on your CAB-1 Remote Controller.

The L.E.D. illuminates for one second.

5. Replace the jumper on the BPC unit.

At this point, the BPC unit is set to control the proper number of blocks through your TPC(s).

Wiring Your Block Power Controller

LED

Note!

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Nessun commento

BPC PowerMaster Manuale Utente Pagina 7